On the other hand, they may cause fire accidents. 'Longevity' tactic 7: Avoid pressure If the tire casing is stored for a long time and is not turned over in time, it will deform due to extrusion; the paper filter element of the air filter and the fuel filter cannot reliably filter if it is squeezed; Rubber oil seals, triangle tape, oil pipes, etc. cannot be squeezed either.'Longevity' tactic*: Avoid heat auto parts-engine piston temperature is too high, it is easy to cause overheating and melting and hold the cylinder; rubber seals, triangle tape, tires, etc.
The fifth 'longevity' trick: avoid washing For the paper air filter element of the engine, no oil can be used for cleaning; for leather parts, it is not suitable to use oil for cleaning. 'Longevity' tactic three: avoid dirty auto parts-fuel filter, oil filter, air filter, hydraulic oil filter and various filters and other parts if they are too dirty, it will lead to poor filtering effect., if they are close to the fire source, will be prone to deterioration or damage. overheat, easy to premature aging, performance degradation, and shorten the service life; starter, generator The coils of electrical equipment such as, regulators are overheated, and they are easily burned and scrapped. are stained with oil, which will threaten driving safety.; engine connecting rod bolts, flywheel bolts, drive shaft bolts installed cotter pins, locking screws, safety plates or If the spring washer and other Aluminum alloy machining products anti-loosening devices are missing, they may cause serious failures during use; if the oil nozzle used to lubricate the gear in the engine timing gear chamber is missing, it will cause serious oil leakage.
The longevity of 'longevity': avoiding near fire Rubber products such as tires, triangle tape, cylinder liner water blocking ring, rubber oil seal, etc. 'Longevity' tactic two: avoiding opposition Auto Parts-The engine cylinder head gasket cannot be installed reversely, otherwise it will cause premature ablation and damage to the cylinder head gasket; the engine fan blades cannot be reversed when installing; for directional pattern tires and chevron tires, install The rear ground impression should point the tip of the herringbone towards the back. 'Longevity' tactic four: avoid deficiencies Engine valve lock plates should be installed in pairs, if missing or missing, it will cause the valve to lose control and damage the piston, etc.
Eighth of 'Longevity': Avoid repetition Some parts should be used once, but individual drivers or repairers reuse them for saving or because they don't understand the 'taboo', which can easily lead to accidents. The sixth 'longevity' trick: avoiding oil The paper filter element of the engine dry air filter, if it is stained with oil, will easily draw the higher concentration of mixed gas into the cylinder, resulting in insufficient air volume, increased fuel consumption, and reduced engine power; if the triangle tape is stained with oil, It will accelerate its corrosion and aging; brake shoes, dry clutch friction linings, brake bands, etc. Tire rubber is very sensitive to oil corrosion, and contact with oil will soften or peel the rubber. Dirty parts such as water tank heat sink, air-cooled engine block and cylinder head heat sink, and cooler heat sink will cause poor heat dissipation and high temperature
